Peptide COA Verification — Batch Lookup & Purity Testing
A certificate of analysis is only worth the checks you run against it. This page lists what a peptide COA has to contain, five checks that catch a recycled or forged document, and what the HPLC and mass-spec numbers actually mean for the lot in your hand.
The most common failure in peptide purchasing is not a bad product. It is a good certificate attached to the wrong vial. Verification is the step that catches it.
What a peptide COA has to contain
A certificate that omits any line below cannot be verified, only believed.
| Field | Why it matters |
|---|---|
| Product name and lot number | The lookup key. Without a lot number the document is not batch-specific. |
| Manufacture or release date | Distinguishes a current lot from a recycled document. |
| Appearance | Lyophilised cake, powder, colour — the first physical check on receipt. |
| Purity by HPLC, with chromatogram | Peak area percentage plus the trace. A number without a trace cannot be audited. |
| Mass-spec confirmation | Expected versus observed molecular ion. Confirms identity, not just cleanliness. |
| Analytical method | Column, gradient, wavelength, run time — so the result can be reproduced. |
| Storage instruction | Temperature and light condition the release data was based on. |
Five checks that catch a recycled or forged certificate
- Cross-check the lot number. It must appear on the vial label, the packing list and the certificate, character for character.
- Compare the chromatogram shape. A forged certificate often reuses a trace from another product. The retention time and peak pattern will not match the method described.
- Check the method against the run. If the stated gradient and run time cannot produce the shown retention time, the trace came from somewhere else.
- Look at the mass window. The observed ion must sit within the expected mass for the stated sequence, allowing for the adduct shown.
- Check the date logic. A release date earlier than the manufacture date, or a certificate dated the same for several different lots, is a document-control failure.
Any one of these failing is enough to hold the lot. Two failing usually means the certificate was not produced for that batch at all.
Independent re-testing. If the lot is going into a regulated workflow, send a sample to a third-party laboratory and compare its chromatogram with the supplier’s. This is the only check the supplier does not control.
Reading the HPLC and mass-spec numbers
Purity by peak area
Purity is the target peak’s area as a share of total integrated area at the certified wavelength. It is a measure of how much of the UV-active material is the intended peptide. It says nothing about water content, residual salts or sterility — those are separate tests.
What a high purity figure does not tell you
- Whether the sequence is correct — that is the mass-spec check.
- Whether the fill weight matches the label — that is a weighing check.
- Whether the lot is sterile — research-grade product is not sterility tested unless stated.
- Whether it has been stored correctly since release — that is the cold-chain record.
Mass-spec confirmation
The observed molecular ion is compared with the theoretical mass for the stated sequence. A match confirms identity; a mismatch means the lot is a different molecule regardless of how clean the chromatogram looks.
Batch COA lookup: how to check a lot before you order
A batch COA lookup starts with the exact lot that will ship, not a sample certificate from the product page. Then run the five checks above against it. If the certificate is for a different lot, the answer is “send the right one”, not “it is the same product”.
- Supplier profile — what we document per lot
- Bulk supply — pack formats and export documents
- Catalogue — 61 items, certificate per lot
- 288 guides — testing, release and supplier qualification
Documentation reading
Ask for the certificate for the lot that will ship
Send the product and the quantity you are evaluating. We return the batch certificate, the method summary and the storage instruction for that specific lot.
