Home  /  Research compounds  /  GHK-Cu Research Peptide
Compound data file · research use only

GHK-Cu Research Peptide — Purity, COA & Batch Data

GHK-Cu is the tripeptide Gly-His-Lys bound to copper(II). The peptide alone weighs 340.4; the complex weighs 401.9, and the difference is the point: a certificate that reports only the peptide mass has not shown that copper is present.

401.91Cu complex
340.38free peptide
89030-95-5CAS

The GHK-Cu peptide is the only compound in this set where the supplied material is a coordination complex rather than a single chain. That changes what a certificate has to prove: not just that the tripeptide is there, but that the copper is bound to it in the right ratio.

Compound identity

Sequence Gly-His-Lys · Cu(II)
Chain length 3 amino acids, complexed with one copper(II) ion
Free peptide mass 340.38 g/mol
Complex mass 401.91 g/mol; C14H22CuN6O4
CAS registry 89030-95-5 (copper tripeptide-1, prezatide copper)
Appearance Deep blue to blue-green powder; the colour is the copper d-d transition
Supplied form Lyophilised blue powder
Storage (powder) −20 °C, desiccated, protected from light

Colour is a data point, not a decorative property. A GHK-Cu lot that arrives white or grey is not carrying copper in the expected coordination environment, whatever the label says.

Complexed, not blended

There are two ways to put copper and a tripeptide in the same vial. One is to bind them, so the copper sits in the coordination site formed by the histidine imidazole and the terminal amine; the other is to mix a copper salt with the peptide and rely on the label. The two are hard to separate analytically at a glance and easy to separate on a UV-Vis scan, because only the coordinated complex shows the broad absorption band near 600 nm. A supplier who cannot state copper content per lot has probably not measured the difference, and a buyer comparing GHK-Cu on price alone is usually comparing a complex against a blend without knowing it.

How GHK-Cu identity is confirmed lot by lot

The first check is the mass: 401.91 for the 1:1 complex against 340.38 for the free tripeptide. A certificate that reports only the lower figure is describing the peptide, not the product. The second check is copper content, whether by atomic absorption, ICP or a stated stoichiometric assay; a 1:1 complex that is 60% loaded will pass a peptide assay and fail its intended use.

The third check is optical. The complex absorbs broadly around 600 nm from the copper d-d transition, which gives a quick and non-destructive way to confirm that copper is coordinated rather than merely present as a counter-ion. A UV-Vis scan is not a release test on its own, but it is a fast way to catch a lot that was blended rather than complexed.

  • Observed mass at 401.91 for the 1:1 complex.
  • Copper content stated, with the method used.
  • Visible absorption consistent with a coordinated copper centre.
  • HPLC purity with the trace attached.
  • Appearance recorded as blue rather than white.

Purity, impurities and what the COA should show

GHK-Cu purity has to be read in two families: peptide impurities, which behave like any tripeptide, and metal-related ones, which do not appear in a standard peptide assay at all. Free peptide is the most common of the second kind, and it is invisible on a purity figure that only integrates peptide peaks.

Free peptide and uncomplexed copper

A lot that is partly uncomplexed will assay high on peptide content and low on copper. If the certificate reports peptide purity only, there is no line that would catch it, which is why copper content belongs on the certificate for this compound rather than in a separate specification.

Light and pH sensitivity of the complex

The complex is not indefinitely stable in solution: light, alkaline pH and competing chelators all shift the equilibrium towards free copper. That is a handling issue rather than a release issue, but it explains why a stock that was blue on the first day can fade over weeks.

  • Purity by HPLC with the chromatogram.
  • Complex mass and copper content on the same lot.
  • Appearance and colour recorded.
  • Form stated, including the counter-ion.
  • Storage and light instruction the release data was based on.

Reconstitution and storage for laboratory stock

GHK-Cu dissolves in water to a clear blue solution. Keep it away from chelators, and keep it out of the light; both act on the copper centre rather than on the peptide backbone.

Solvent Sterile water or a neutral buffer; no EDTA, no citrate, no phosphate in excess
Working stock 1–5 mg/mL
pH Slightly acidic to neutral; alkaline pH promotes hydrolysis of the copper bond
Chelators Avoid EDTA, EGTA and citrate — they will strip the metal
Light Amber vial, foil wrap; the complex is light-sensitive
Powder storage −20 °C, desiccated, sealed

No chelators in the buffer.

Ordering GHK-Cu: pack sizes and batch documents

Held as ten-vial kits in two fills. The GHK-Cu COA for each lot states the complex mass and the copper content, because the peptide mass alone would not identify the product.

Pack Format Price
50 mg × 10 vials 10-vial kit $25
100 mg × 10 vials 10-vial kit $45

A GHK-Cu supplier selling a blend rather than a complex will usually show no copper figure. Prices are per kit at the time of writing and are confirmed on the product page. Larger fills, blends and export documents are quoted through bulk research peptides.

Need the copper content stated on the certificate?

Send the fill you are evaluating. We return the complex mass, the copper content and the certificate for that lot.

VIEW GHK-CU